Yanmar 6LPA-STZP2 Spécifications télécharger pdf (Page 79)

6LPA Series Operation Manual 73

LONG-TERM STORAGE

If the engine will not be used for an

extended period of time, special measures

should be taken to protect the cooling

system, fuel system and combustion

chamber from corrosion and the exterior

from rusting.

The engine can normally stand idle for up

to 6 months. If it remains unused for longer

than this, please contact your authorized

Yanmar Marine dealer or distributor.

Before performing any storage procedures

within this section, review the Safety

section on page 3.

In cold temperatures or before long-term

storage, be sure to drain the seawater from

the cooling system.

NOTICE

DO NOT drain the coolant system. A full

coolant system will prevent corrosion and

frost damage.

If seawater is left inside of the engine, it

may freeze and damage parts of the

cooling system when the ambient

temperature is below 0°C (32°F).

PREPARE ENGINE FOR

LONG-TERM STORAGE

Note: If the engine is close to a

periodic maintenance interval,

perform those maintenance

procedures before putting the

engine into long-term storage.

1. Wipe off any dust or oil from the outside

of engine.

2. Drain water from fuel filters.

3. Drain fuel tank completely or fill the

tank to prevent condensation.

4. Grease the exposed areas and joints of

the remote control cables and the

bearings of the remote control handle.

5. Seal the intake silencer, exhaust pipe,

etc. to prevent moisture or

contamination from entering engine.

6. Completely drain bilge in hull bottom.

7. Waterproof the engine room to prevent

rain or seawater from entering.

8. Charge the battery once a month to

compensate for battery’s

self-discharge.

9. Remove key from key switch and cover

the key switch with moisture cap.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 105 106

Commentaires sur ces manuels

Pas de commentaire